再生高含盐水景观河道生态修复工程水质净化效果

通过对天津经济技术开发区泰达再生高盐水景观河道生态修复工程实际水体水质变化情况进行研究，分析了滨海盐碱地区高盐再生水景观河道水体生态修复工程的水质净化效果以及河道盐份动态变化规律。研究结果表明：水体中主要污染物COD浓度在54．15～94．15mg／L范围内变化，几乎没有去除；氖磷净化效果非常明显，它们的最大去除率分别为TN69．35％、NH3-N50．75％、NO3^--N71．89％、TP56．97％、po^3-4-p81．02％；河道水体全盐量（TDS）浓度在4300～5200mg／L范围内波动，TDS浓度有所升高，增加量不大，只有850mg／L左右，表明洗盐基本结束。由此说明生态修复工程对泰达再生高盐水景观河道水环境质量改善效果明显。     

凉水塔技术研究与探讨

通过对我厂引进的大型进口设备———Marley—600型冷却塔进行技术改造情况的介绍,具体分析了进口材料与国产材料的本质区别,并具体介绍了我厂的使用情况。此次技术改造在大化肥行业是首次进行,并取得了成功。论证了进口设备走国产化道路的必然性及可行性,从而为我国的其他大型Marley—600型冷却塔设备走国产化道路作了较好的铺垫。     

超稠油污水处理技术的研究

以河油田曙I区社84污水处理站含超稠油污水为对象，选用最新研制开发的HL－005高效除油剂，研究了药剂浓度及复合比例对污水的处理效果。结果表明，在现有工艺条件下，使用该药A与C两组分复合先对污水进行预处理,然后A与B两组分复合对预处理后的水质进行净化，在技术上是可行的，完全达到水质净化指标。     

新型组合工艺对微污染原水中有机污染物和消毒副产物前体物的去除

本采用中试试验装置研究了生物陶粒过滤一微絮凝砂滤一活性炭吸附组合工艺，对微污染原水中有机污染物和消毒副产物前体物的去除效果。在原水UV254为0．047～0．065cm^-1，DOC为2．70～4．10mg／L，TOC为3．50～5．00mg／L的条件下，组合工艺对UV254，DOC、TOC平均去除率分别为98．4％、74．1％、69．2％。色-质联机分析结果表明，经组合工艺处理水中有机物由54种降至25种。组合工艺出水中三卤甲烷总含量不及常规工艺出水中该物质含量的五分之一。组合工艺能有效控制和消除水中有机物的污染，提供安全的优质饮用水。     

SBR法处理校园生活污水为中水的试验研究

根据校园生活污水的水质特点,选择SBR工艺对校园生活污水进行了试验研究,确定了最佳的运行参数。试验结果表明,当采取最佳操作条件运行时,COD、NH4-N、PO43-、BOD5的去除率分别达到了88%、98%、94%、96%以上,其出水色度、嗅味和pH也均达到了中水主要水质标准,处理效果稳定,该试验为校园生活污水的中水回用提供了重要的技术参数。     

聚合硅酸铝铁絮凝剂的研究动态

概要评述了国内外聚合硅酸铝铁盐类混凝剂的研究动态。分析了各种制法的特点，对今后的研究工作提出了一些建议。     

Preparation of water‐repellent silks by a reaction with octadecenylsuccinic anhydride

Silk fibers and membranes were acylated with octadecenylsuccinic anhydride (ODSA) at 75°C for different times. Swelling [N,N‐dimethylformamide (DMF) and dimethyl sulfoxide (DMSO)] and nonswelling (xylene) solvent media were used for the reaction. Silk membranes that reacted in DMF or DMSO displayed faster reaction kinetics and attained higher weight‐gain values than fibers. The effect of the solvent on the reaction yield was in the following order: DMSO > DMF ? xylene. The Fourier transform infrared spectra of acylated silk samples showed the characteristic absorption bands of the anhydride at 2990, 2852, 1780–1700, and 1170 cm^?1. The intensity of the latter band, which increased linearly with the weight gain, was used as a marker for evaluating the reaction kinetics of the samples acylated in the nonswelling medium. The moisture regain and water retention of silk fibers acylated with ODSA decreased significantly, regardless of the solvent system used. Accordingly, the water repellency increased. Acylation induced an increase in the thermal stability of the silk fibers and membranes. Fine particles adhering to the surfaces of the silk fibers acylated in xylene were detected by scanning electron microscopy. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 89: 324–332, 2003     

多孔TiO2陶瓷光催化剂降解糠醛废水

以钛酸四丁酯等为原料，采用简单工艺制得多孔TiO2陶瓷光催化剂；并研究了利用多孔TiO2陶瓷光催化降解糠醛废水。结果表明，在紫外灯下照射60min，糖醛废水的COD去除率可达59．8％，而通入空气有利于污染物的去除。     

超临界水中氧化钙催化泥炭制氢

使用间歇式超临界水反应器,以氧化钙作为催化剂和CO_2化学固定剂,详细考察了Ca/C摩尔比、反应温度、停留时间、压力等条件对泥炭在超临界水中转化制氢的影响。在873 K,Ca/C比为0.61时,CO_2几乎被完全固定,在气相产物中只有氢气、甲烷和低碳烃,碳转化率由未添加CaO时的66.6％提高到82.4％,氢气的产率由2.2 mmol·g~(-1)提高到6.9 mmol·g~(-1)。当反应温度由773 K提高到923 K时,泥炭的裂解反应加剧,气体产物的收率由5.5 mmol·g~(-1)提高到19.5 mmol·g~(-1),但是氢气所占比例由55.4％下降到34.8％。与温度相比,压力和在终温停留时间的影响相对较小。     

Surface modification of tetrafluoroethylene–perfluoroalkyl vinylether copolymer (PFA) by plasmas for copper metallization

Tetrafluoroethylene–perfluoroalkyl vinylether copolymer (PFA) sheet surfaces were modified with argon, helium, oxygen, and hydrogen plasmas. How the four plasmas modified the PFA sheet surfaces was investigated. All plasmas modified the PFA surfaces and at the same time initiated degradation of the PFA polymer chains. The balance between modification and degradation was strongly influenced by the magnitude of the discharge current in the plasmas. Efficiency of the plasmas in modification was hydrogen plasma > oxygen plasma > argon plasma > helium plasma. The modification involved defluorination of CF₂ carbons into CHF and CH₂ carbons and oxidation into O? CH₂, O? CHF, and O? CF₂ groups. The surface‐modification technique (a combination of hydrogen plasma treatment and silane coupling treatment) proposed in this study was applied for copper metallization of the PFA surface. The utility of the technique was confirmed. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 1087–1097, 2002